Title Page or Report Header. (Marked deduction if missing, no marks allocated if complete: -5 % of report mark if any information missing)
This should include the title of the experiment, the date, your complete name and student number, your partner’s name (do not include their student number) and your TA’s name.
Experimental objectives. (5 % of report mark) State clearly in one or two sentences what the experiment is designed to demonstrate or measure.
Procedure and Observations. (10 to 15 % of report marks) Describe briefly (in a few sentences) the procedure. Do not rewrite the lab manual instructions – you may reference the lab manual rather than rewrite it. HOWEVER you should include information such as the amount of time a solution was actually boiled, how much acid was added and its actual concentration, the colour changes observed etc. Results and Discussion. (45 to 50 % of report mark) A photocopy of signed raw data is to be attached to your report.
This section (as all others) is to be written in sentences and paragraphs (not point form). It MUST include text as well as tables and graphs including a paragraph describing all visual observations (colour change, phase change, gas formation etc.) While it is a good practice to organize results into a table/graph wherever possible, the text must refer to the tables and graphs. All tables must have complete captions (located above the table) describing fully what data is presented in the table. If calculations are involved, give a sample calculation showing clearly how the calculated number was obtained. Always give the appropriate number of significant figures, and the units. Data may be presented graphically. All figures must have a complete caption (located below the figure) and should be referenced in the text. Figure and Table captions should be sufficiently detailed that the reader does not need to read the text to know what is shown. The discussion, including interpretation of results, is the most important part of the report. Describe what the results mean, and include balanced chemical equations where they are appropriate. You should present some perspective on the numbers you obtain – do they make sense, if yes why do you draw this conclusion, if not, why? What are sources of error? What else could you have done? How could the experiment have been improved? This may require outside research and should be referenced appropriately.
Calculations. (5 to 15 % of report mark) At least one example of each kind of calculation must be included using appropriate significant figures. Errors (relative or absolute) are required wherever possible.
Conclusion. (Mark deduction if missing, no marks allocated if complete: -5 % if document does not include a quality conclusion)
Should reflect the objectives of the experiment, and include relevant results (including sample numbers).
References. (5 % of report mark) You are expected to use scientific literature,chemistry textbooks, valid internet sites to support your analysis and discussion and should include any sources you accessed – these should be presented in accepted an ACS style. If your only reference is the lab manual, your score for this section will be 0.
Are you looking for a similar paper or any other quality academic essay? Then look no further. Our research paper writing service is what you require. Our team of experienced writers is on standby to deliver to you an original paper as per your specified instructions with zero plagiarism guaranteed. This is the perfect way you can prepare your own unique academic paper and score the grades you deserve.
Use the order calculator below and get started! Contact our live support team for any assistance or inquiry.[order_calculator]